The reasons for the power drop in the Generator as follows:

1. The air filter is too dirty and the intake air is not enough;

2. The fuel filter unit is too dirty and the fuel injection amount is insufficient;

3. The ignition time is not correct;

4. The degree of insulation of the generator is also deteriorating.

Due to the above factors, the output power of the generator set will become smaller, and the power requirements of the generator will not be achieved. At this time, the generator manufacturer experts proposed the following solutions:

First, the new air filter must be cleaned or replaced. Replace or clean the diesel oil and water separator. Then adjust the ignition time. In this way, the power of the generator set may resume again, perhaps returning to the customer's calibration power requirements.

In fact, Diesel Generator sets are like cars. Because they work by inhaling air, there are more dirt in the air. Therefore, after a long time, the air filter must be cleaned or replaced. In short, each generator set should be regularly maintained during use, so as to ensure that the power consumption of the generator set does not decrease, ensure the service life of the generator set, and regularly maintain the generator set, which not only can extend the life of the generator but also improve the life of the generator. The working efficiency of the unit.